Minicom Advanced Systems IP Control User's Guide download pdf (Page 36)

SMART IP ACCESS

33. Reset

Hard Reset

KB-Power™ and KB-Power IPMI™ offer a power control over remote electronics

devices through a remote session.

Select Power to send a Power Cycle command to the remote electronic device.

(Such as the Target Server)

Only a user with administrative privileges can initiate a Hard Reset command.

Power Management Console

The Power Management Console can be accessed when the Power Management

Console is activated. Only users with Administrative privileges can access it.

34. Troubleshooting – restoring factory defaults

Section 23 on page 23 explained how to restore factory settings from the Web

interface. When you cannot access the system e.g. you have forgotten the

Username or Password, you can restore factory defaults from the Smart IP Access

unit.

To restore factory defaults:

1. Switch on the unit.

2. Within 3 seconds of switching on, press the Reset and Local buttons

simultaneously.

3. Release the Reset button. The Remote LED illuminates.

4. Release and re-press Local Button. The Remote LED turns off.

5. Wait 2 minutes until the unit finishes booting.

6. Login to the lower network interface (LAN 2) to the default IP address of the

unit: http://192.168.0.155/config. The Login box appears see Figure 26.

Figure 26 The login box

1 2 ... 31 32 33 34 35 36 37 38 39 40 41

No comments

Minicom Advanced Systems IP Control User's Guide Page 36