Minicom Advanced Systems IP Control User's Guide download pdf (Page 29)

USER GUIDE

Hide Toolbar – Check this option to hide the Toolbar from the next reconnection

onwards. To toggle the Toolbar on and off, press F9. See above page 19.

Full Screen Mode - Check this option to make the remote session screen appear in

full screen mode from the next reconnection onwards. To toggle the full screen

mode on and off, press F11.

23.11 Disconnecting the remote session

To disconnect the session, on the Toolbar, click . The Login box appears. You

can re-login or close the browser window.

24. Troubleshooting - Restoring factory defaults

Section 21 on page 17 explained how to restore factory settings from the Web

interface. When you cannot access the system e.g. you have forgotten the

Username or Password, you can restore factory defaults from the IP Control unit.

To restore factory defaults:

1. Press and hold down the Go-Local button for 3-4 seconds while powering up

the IP Control. The device boots up in safe mode.

2. Wait until the unit finishes booting.

3. Login with the default IP address of the unit: http://192.168.0.155/config. (Do

not start the address with https). The Login box appears see Figure 23.

Figure 23 Login box

4. Type username: admin , password: SAFEmode. (Case sensitive). This

username and password works only after the reset procedure described above. A

menu appears.

1 2 ... 24 25 26 27 28 29 30 31 32 33

No comments

Minicom Advanced Systems IP Control User's Guide Page 29